How do I connect my Power Commander 3 to my computer?
Table of Contents
Hassle free USB communication – The Power Commander USB will instantly and automatically connect to the Power Commander Control Center software once it is installed. Simply “power up” the unit and connect the supplied USB cable to the computer and PCIII USB.
How much horsepower does a Power Commander 3 add?
The Power Commander is a tuning tool to adjust fuel, and on some models ignition timing. Just adding a Power Commander to a completely stock vehicle usually does not increase peak horsepower. It usually will improve drivability, throttle response, and mid-range horsepower and torque.
What does a Dynojet Power Commander 3 do?
The Power Commander 3 USB provides precise information for fine-tuning fuel-injected motorcycle with upgraded air filters, aftermarket exhaust systems or engine modifications. Each unit includes a built-in microprocessor and a base map designed to improve engine performance over stock.
How do you program a Dynojet Power Commander 3?
With the ignition off, hold down all three buttons on the Power Commander III unit. While still holding down the buttons, turn on the ignition and start the bike. Release the buttons. The light(s) should show up in the last place they were left, by default the center two lights.
How do I connect my Power Commander to my computer?
Plug your Power Commander V into your computer using the supplied USB cable. The port on the Power Commander V is located on the right side of the device and is weather protected by a rubber strip that you can peel back. Click View > Show Notes to see a description of the map on your device.
How much horsepower does a Power Commander add to a motorcycle?
Registered. SteveMcqueen said: a full system with a power commander should be good for around 115-118 Hp on the 04…
Can Power Commander 3 be used on different bikes?
Life Member. Yes, you can move your PCV to the other bike as both bikes use the same one (Part # 15-011). You will however need to go to the Power Commander website and download a new map to the PCV that matches your current setup for the 2012.
How do I manually adjust Power Commander 3?
To adjust the buttons on your Power Commander III, follow the instructions below:
- With the ignition off, hold down all three buttons on the Power Commander III unit.
- While still holding down the buttons, turn on the ignition and start the bike.
- Release the buttons.
How do you remap a Power Commander?
Hold down all three buttons on the face of the Power Commander unit and turn on the bike’s ignition. Release all the buttons once the engine is idling normally. The Power Commander manual recommends waiting approximately 20 seconds before making any adjustments.