How do I fix F35 error?
Table of Contents
To reset the F35 error, unplug your Whirlpool washing machine for 10–20 minutes. Look at the display: does the malfunction code appear again? If it doesn’t help and the F35 error appears again, you need to provide repair work.
How do I fix the Sud error on my Maytag washer?
This type of liquid chlorine bleach contains a thickening agent that may create excess suds in washers. If this is the case, run the washer empty, using regular liquid bleach products, or clean with affresh® washer cleaner before running another load. affresh® cleaners are available at many retailers.
What does it mean when my washer says suds?
It means you are using detergent improperly. If your washing machine has the word “SUDS” on the display, it has detected an over-sudsing condition, and will stop for a short period to allow the suds to dissipate. This error code is usually caused by too much detergent, or the wrong type of detergent.
What does the error code F35 mean on a Whirlpool washer?
The “F35” error code is indicating a problem with the water level pressure switch operation (key#20). There could be a blockage in the air dome or pressure switch hose (key#21). The air dome is located on the back of the tub on the left hand side.
Where is the water level switch on a Whirlpool washer?
Look for the water level switch on the right side of the cabinet toward the back of the washer. The round water level switch attaches to the side of the cabinet. A rubber tube connects the water level switch to the washtub.
How do I fix my Maytag SD error?
Maytag acknowledges that error codes like “Sd” sometimes appear by mistake. Push the “Pause/Cancel” twice or “Power” button once to remove the code from the screen and try using the washer again. If the code returns, unplug the washer for 60 seconds and try the cycle again before calling for assistance.
How long does Sud error last?
5 minutes to 40 minutes
When there is an excessive amount of detergent present, the display flashes a SUD Error number, and the washer slows its work to allow the foam to dissipate before continuing the cycle. It can take anything from 5 minutes to 40 minutes, depending on how much powder is in the water.
How do I fix SD error code?
Simply put, too much detergent was used and an excessive amount of suds or foam was produced. Adding an additional rinse cycle without adding any more detergent might fix this problem. Sometimes the machine will automatically detects this problem and add a pause and additional rinse cycle in order to break up the suds.
Why is my Whirlpool washer not draining?
When the drain hose is kinked, bent, blocked or clogged, the washer won’t drain. To handle the blockage problem, disconnect the drain hose and give it a good cleaning. Then, reconnect the drain hose to the machine, turn the electricity back on and run the rinse/spin cycle to see if the washer is draining properly.