What grit sandpaper do you use between coats of polyurethane?
Table of Contents
320-grit sandpaper
Allow each coat to dry fully. To give the subsequent poly layers something to bond to, sand lightly between coats with 320-grit sandpaper wrapped around a hard block. Note: The first coat needs the most sanding to appear smooth; don’t worry if it doesn’t look as flawless as you’d like at first.
Do I need to sand polyurethane between coats?
Yes. Minwax Polyurethane should be sanded between coats. Sand with 320 grit sandpaper to get rid of any fine particles of dust that have settled on it while it was still wet. Sanding in this case not only allows for a smoother finish but can also help abrade the surface and increase inter-coat adhesion.
Is two coats of polyurethane enough on hardwood floors?
OIL BASED POLYURETHANE: We recommend at least 2 coats of oil based polyurethane + a lacquer sealer coat as a minimum for hardwood flooring. Extra coats = extra protection, but only one coat of oil based polyurethane may be applied per day, as it needs 24 hours to dry before applying another coat.
How long should polyurethane dry before sanding?
Apply two to three additional coats of full-strength polyurethane, sanding between each coat. When applying polyurethane, brush along the grain, stretching the polyurethane into as thin a coat as possible. Always allow polyurethane to dry 24 to 48 hours before sanding, to give the surface time to cure and harden.
How do you smooth the final coat of polyurethane?
Sand lightly with 240-grit sandpaper between coats, then let the last coat dry for at least 24 hours. This is standard practice with any wood finishing job, and is nothing out of the ordinary. That said, sanding bare wood beforehand to create a smooth foundation is key.
Do you sand the last coat of polyurethane?
No, you don’t need to sand the final coat of polyurethane. The only time you should sand the final coat of polyurethane is if you haven’t gotten a smooth finish. Different problems can occur when you apply polyurethane, such as dust nibs, bubbles, and streaks.
Do you sand after final coat of polyurethane?
How long should polyurethane dry between sanding?
In-between Coats When applying polyurethane, brush along the grain, stretching the polyurethane into as thin a coat as possible. Always allow polyurethane to dry 24 to 48 hours before sanding, to give the surface time to cure and harden.
Can you wait too long between coats of polyurethane?
It’s all about adhesion. When you recoat after 2 hours you get a chemical bond between layers. If you let it go longer than that, you need to wait 24 hours so it’s hard enough to sand and get a mechanical bond.